GtoI Corporation

Cooling System

cooling system visual

Chiller
Water-Cooling
Air-Cooling
Cooling / Warming Controller
Temperature Controller
Water-Heater
Double Water Heater
High Temperature Oil-Heater (320¡É)
High Temperature Oil-Heater (250¡É)
Oil-Heater (150¡É)

leftMenuBg02

topmarginimg

Home > Cooling System > Temperature Controller > Double Water Heater
Cooling System
Temperature Controller Double Water Heater
Internal structure Schematic diagram of fluid

    Excellent reproducibility of high-quality control process being accomplished by thoroughly intercepting the causes of inferiority in the ill-balanced die control process

  • The speed of response to high temperature being fast
  • Safe structure, durability
  • Temperature setting is 30~95¡É
  • High-temperature and high-pressure large discharge pump adopted
  • Microminiaturized, light-weighted
  • Selective models between unified and detached models
  • Proportionate control function of warmth and coolness
  • Selected model type : TCW-00LS, LD, MS, MD

  • TCW-00 : Peculiar standard model/Media flux
  • TCW-L : Media temperature control
  • TCW-M : Die temperature control
  • TCW-S : Single type
  • TCW-D : Double type

    Mold Temperature Controller
    state of operation shown self-analysis of the causes of trouble media temperature control(LS, LD)
    PCB electronic control alarm function and an emergency light die temperature control(MS, MD)
    one-touch operational panel warm up operation function detached control system(Option)
    heating and cooling type PDI temperature control function high-low alarm device die distributor (Option)
    non contact SSR adopted(Option) graphic forwarding function of temperature data(Option)

      Internal structure

      Double water heater can give satisfaction in superprecise molding because it can intercept the causes of defects and maximize elevated level of temperature maintenance by separating die temperature into moving die and fixed die.

      It is very suitable for dividing temperature into moving die and fixed die and managing them when the temperature of die cannot be maintained equally according to the temperature changes of injection molding resin and the external temperature changes.


      Schematic diagram of fluid



topmarginimg
rightMenu_bg01
rightMenu_top01
logo
tel 8232-822-7974
fax 822-6306-4432
mail gtoi@gtoic.com
rightMenu_bottom01
topmarginimg
ex_top
topmarginimg
topmarginimg
topmarginimg
topmarginimg